Preparation before starting the motor

Release time:

2023/01/17 10:34

Preparation before starting the motor
In order to ensure the normal and safe start of the motor, the following preparations should be made before starting:
(1) Check whether the power supply has power and whether the voltage is normal. If the power supply voltage is too high or too low, it should not be started.
(2) Check whether the starter is normal, such as whether the parts are damaged, whether the use is flexible, whether the contact is in good contact, and whether the wiring is correct and firm.
(3) Whether the fuse size is appropriate, whether the installation is firm, and whether there is fuse or damage.
(4) Check whether the connector on the motor terminal board is loose or oxidized.
(5) Check the transmission device, such as whether the belt is properly tightened, whether the connection is firm, and whether the screws and pins of the coupling are tight.
(6) Drive the rotor of the motor and the shaft of the load machine to see if it rotates flexibly.
(7) Check whether the motor and starter housing are grounded, whether the grounding wire is open, and whether the grounding screw is loose or falling off.
(8) Remove the sundries around the motor and remove the dust and oil dirt on the base surface.
(9) Check whether the loaded machinery is properly prepared for starting.
(10) For the winding motor in normal operation, the motor slip ring shall be frequently observed for eccentric oscillation; Observe whether the spark of the slip ring is abnormal. Whether the carbon brush on the slip ring needs to be replaced.

See more...

Disclaimer: The content is forwarded from the Internet, and this website does not own the ownership or bear the relevant legal liability. If you find that this website has content suspected of plagiarism, please go to contact us to report and provide relevant evidence. Once verified, this website will immediately delete the suspected infringing content.

Previous:

Next: